From: "David W. Hodgins" <dwhodgins@nomail.afraid.org>

On Fri, 01 Jun 2018 12:38:26 -0400, Shadow <Sh@dow.br> wrote:
> 	Yes, they changed it after I last accessed it.
> 	It now points to:
> https://support.kaspersky.com/14221
> 	And although it says you can boot it from a USB (in system
> requirements), they don't tell you how to.
> 	The old link to the Rescue2usb utility has been removed.
> 	Sh*tty support ....
> 	[]'s

Found the correct link at https://support.kaspersky.com/viruses/krd2018
which leads to downloading
https://rescuedisk.s.kaspersky-labs.com/updat...

Checking out the iso image, it's a customized isohybrid build of gentoo
linux, suitable for burning to an optical disc, or copying to a usb
device.

To copy such an image to a usb device, this page has links to a few
programs that can be used. The page is for Mageia linux, but the
instructions  will work for a Gentoo linux iso image too.
https://wiki.mageia.org/en/Dump_Mageia_ISO_on...
ools

One important thing to understand, is that the iso image contains it's
own partition table, so when copying it to a usb flash drive, it has
to be copied to the drive, not to an existing partition on the drive.

If the drive currently has any partitions on it, make sure they are not
mounted.

Any data currently on the drive, including it's partition table will be
overwritten.

Be patient when copying the half gig iso image to the usb drive. It will
take a while, as they are much slower than a hard drive. Depending on
the usb drive, and other factors, it may appear to complete quickly,
even though it's still being written. Give it at least 5 minutes.

When you reboot the computer, if it ignores the usb stick and tries to
boot directly to the hard drive reboot it again, and watch for any
sort of a message such as "Press f7 for setup". Which key needs to be
pressed will vary depending on the computer's bios. Once in the setup,
look for any options similarly worded to "boot order", and in that
section ensure the usb device entry is moved to be before the hard
drive option, then save the setup changes, and reboot, which should
then load the recovery system.

FYI, I'm responding to the article as seen in alt.comp.anti-virus, as
I'm not subscribed to the pc-homebuilt newsgroup.

Regards, Dave Hodgins

-- 
Change dwhodgins@nomail.afraid.org to davidwhodgins@teksavvy.com for
email replies.
--- NewsGate v1.0 gamma 2
 * Origin: News Gate @ Net396 -Huntsville, AL - USA (1:396/4)