's VADV-PHP Home

Message Area

Casually read the BBS message area using an easy to use interface. Messages are categorized exactly like they are on the BBS. You may post new messages or reply to existing messages!

You are not logged in. Login here for full access privileges.

Previous Message | Next Message | Back to Amateur(HAM) Radio TECHnical Con... <-- <---

Return to Home Page

Amateur(HAM) Radio TECHnical Con... [71 / 89]

From

Subject

Date/Time

Alan Beck

ALL

811H problem, please read

October 11, 2018
10:05 AM *

Hi,

I put a pair of 572B tubes  in my AL-811 amp and they died.

One went to a plate current of 600 ma and the other 75 ma.

Anyways, DX engineering tubes are coming.

I checked all my 572B tubes one at a time and selected the best I could for the
 amp. The worst case sceneria was 75 ma.

Here goes.

600 ma
150 ma
85 ma
75 ma.

Am I going to trash my amp or will the output just drop?

It's holding at 500 watts right now. For 100 watts in.

So, should I leave well enough alone or should I only the 2 tubes in there as
soon as they arrive?

If one fails short could that take my amp out?

Best 73,
Alan
VY2XU

--- WinPoint Beta 5 (359.1)
 * Origin: Original WinPoint Origin! (1:229/426.36)

Previous Message | Next Message | Back to Amateur(HAM) Radio TECHnical Con... <-- <---

Return to Home Page

Execution Time: 0.0795 seconds

If you experience any problems with this website or need help, contact the webmaster.
VADV-PHP Copyright © 2002-2024 Steve Winn, Aspect Technologies. All Rights Reserved.
Virtual Advanced Copyright © 1995-1997 Roland De Graaf.
v2.0.140505