| 's VADV-PHP Home |
|
|
Message Area
Casually read the BBS message area using an easy to use interface. Messages are categorized exactly like they are on the BBS. You may post new messages or reply to existing messages! You are not logged in. Login here for full access privileges. |
| Previous Message | Next Message | Back to Amateur(HAM) Radio TECHnical Con... <-- <--- | Return to Home Page |
|
||||||
| From | To | Subject | Date/Time | |||
|
Alan Beck | HAM_TECH | 572B usage in an 811A |
October 11, 2018 9:36 AM * |
||
Hi there, I am looking for advice on something I am doing right now with my Ameritron AL-811H amp. The 572 two 572B tube I had new dropped down in power to 300 Watts. DX Engineering will be sending new tubes. Currently, I measured the plate current on each tube in the amp. I found the following currents of what I put in the amp to achive just 500 watts. 600 ma 150 ma 85 ma 75 ma Now, my question is if One of the tubes fails, can it damage my amp. What is my worst case scenario here? I think I might keep these tubes in it until the power drops and then out the new ones in. 73, Alan VY2XU --- WinPoint Beta 5 (359.1) * Origin: Original WinPoint Origin! (1:229/426.36) |
||||||
|
||||||
Amateur(HAM) Radio TECHnical Con... 
| Previous Message | Next Message | Back to Amateur(HAM) Radio TECHnical Con... <-- <--- | Return to Home Page |
Execution Time: 0.0984 seconds If you experience any problems with this website or need help, contact the webmaster. VADV-PHP Copyright © 2002-2024 Steve Winn, Aspect Technologies. All Rights Reserved. Virtual Advanced Copyright © 1995-1997 Roland De Graaf. |