Hello Golded team,

This may only apply to the Windows versions...


When running Golded it does not use the active code page as set by the CHCP
command, but it uses the default code page that is active when the system is
booted up. In my case code page 850. If there is a way to run it using another
code page, I have not found it.

This "feature" makes it difficult to write messages that use other characters
than those present in the default character set. In my particular case it is
difficult to write messages in Cyrillic. There is the possibility of using an
external editor, but this is cumbersome and normal text editors are based on
text written in lines separated by EOL markers. They can't deal very well with
the concept of "paragraphs" separated by CR, as used in Fidonet messages. Also
the external editor can only be invoked when writing messages, not when just
reading them.

I therefore request that this "feature" is disabled. Preferably configurable
for backward compatibility.

USEACTIVECODEPAGE Yes/No  (default No)


Even more nice would be if the active code page could be set per group:


GROUP  CYRILLIC
       CHCP 866
       member R50.SYSOP
       member R46.SYSOP
       member ru.binkd
       XLATIMPORT CP866
       XLATLOCALSET CP866
ENDGROUP

It would make writing in the language of my eastern friends so much easier if
there was an easy way to let Golded do CP866 on my system. And maybe the other
way around as wel.


Cheers, Michiel


---
 * Origin: Schn├©├©rd (2:280/5555)
SEEN-BY: 116/18 123/140 124/5014 5015 5016 130/803 15/0 153/7715 16/101 18/200
SEEN-BY: 19/25 33 36 50 218/700 220/60 222/2 230/150 2320/100 240/1120 250/1
SEEN-BY: 261/100 38 266/404 512 267/155 275/100 280/1027 282/1031 1056 291/1
SEEN-BY: 111 31999/99 320/119 219 34/999 340/400 342/13 3634/12 387/21 393/68
SEEN-BY: 396/45 5020/1042 712/848 801/161 189 90/1