| 's VADV-PHP Home |
|
|
Message Area
Casually read the BBS message area using an easy to use interface. Messages are categorized exactly like they are on the BBS. You may post new messages or reply to existing messages! You are not logged in. Login here for full access privileges. |
| Previous Message | Next Message | Back to Maximus BBS Discussion And Suppo... <-- <--- | Return to Home Page |
|
||||||
| From | To | Subject | Date/Time | |||
|
Andrew Leary | Robert Wolfe | FD/2 and Max/2 |
September 7, 2017 9:20 PM * |
||
Hello Robert! 07 Sep 17 00:02, you wrote to all: RW> + 06 Sep 23:51:53 MAX Begin, v3.01 (task=1) RW> ! 06 Sep 23:51:53 MAX SYS0032: Cannot open com port (com1) RW> ! 06 Sep 23:51:53 MAX Communications driver not properly installed RW> However, whenever I run Maximus/2 in WFC mode, I do not get the above RW> error message. Do you have the port-sharing parameter added to your SIO command line in CONFIG.SYS? ie: DEVICE=C:\SIO\SIO.SYS (COM1,3F8,IRQ4,-) (COM2,2F3,IRQ3,-) (COM3,INTERNET:3E8,NONE:IRQ4,-) (COM4,INTERNET:2E8,NONE:IRQ3,-) This is for a standard COM1 and COM2, and virtual COM3 and COM4. The dash (-) parameter enables sharing the port between applications. Andrew --- GoldED+/LNX 1.1.5-b20170303 * Origin: Phoenix BBS * phoenix.bnbbbs.net (1:320/219) |
||||||
|
||||||
Maximus BBS Discussion And Suppo... 
| Previous Message | Next Message | Back to Maximus BBS Discussion And Suppo... <-- <--- | Return to Home Page |
Execution Time: 0.0805 seconds If you experience any problems with this website or need help, contact the webmaster. VADV-PHP Copyright © 2002-2024 Steve Winn, Aspect Technologies. All Rights Reserved. Virtual Advanced Copyright © 1995-1997 Roland De Graaf. |